Pattern
6 - Daisy Tool Bookmark
This pattern also makes use of the Slot tool
(Bold) for the ribbon slots and the Suntool ( Large) around the border.
Instructions..
Requirements :140
gsm parchment paper, White ink/gel pen, PCA Special Embossing Mat and
Perforating mat, PCA MediumBall Embosser, PCA Scriber, PCA Bold and Fine
DaisyTools, PCA StampEdge and/or MiniStampEdge, PCA Large SunTool, Bold
SlotTool and 5mm ribbon to thread
through slots.
Tracing
·
Trace
the entire pattern as shown with white ink/gel pen
Embossing
·
Turn
work over and place on Special Embossing mat.
Make the alternate LargeSun impressions, with MediumBall dot markings
around the entire outside perimeter as per pattern.
·
Make
the dot marking along the centre strip in between future slots.
·
Use
your MediumBall embosser to fill in the area between the double lines that
surrounds centre piece.
·
Use
your PCA Scriber to trace over the outside lines to fill them out a little.
Perforating
·
Perforate
the slot bases for the ribbon threading by using a base created with the PCA
BoldSlot tool and then cutting the centre out in the same method that one does
to make crosses. It is
essentially a double cross!
·
Use
your Fine and Bold DaisyTools to follow the pattern markings in the centre
strip, each one is given a slight twist ( hold tool vertically to paper)
before withdrawing tool from paper.
·
Perforate
away the entire outside edge of the strip with your PCA StampEdge/Mini
StampEdge ( for smaller areas) leaving a neat lacy strip.
Finishing
Thread
the 5mm ribbon through the slots along the centre, ensuring that each end is
emerging from the underside of the project, like tails.
Pattern
(right click and save after you click on the thumbnail and open it full size
first)
The bookmark can be made as long or short as
you like by adjusting the pattern, it repeats along it's length.
