PCA CrossSection Tool
The new CrossSection tool is only
available in Fine gauge currently.
It is a 9 needle perforator that has been fashioned to
make the holes in the shape of a large X... 5 needles in either direction.
Think of the borders you can make by lining it up in
rows, side by side, maybe joined up ... one or 2 rows wide? Try a dot of
embossing in between each section perhaps.
It makes the perfect basis for many shapes such as a
snowflake, particularly in conjunction with the new TwigTool in fine gauge.
Try it joined up at each corner as an all over beautiful
lattice type of pattern. It will be lovely either with the diamonds in
each centre left empty or maybe you could emboss alternate centres or even use
your PCA SunTools to make a random impression in the diamond shapes of the
CrossSection lattice work.
Check out the picture above for some samples... this is
a tool you will soon grow to call a favourite!
